Built 1967
Serial No. 190-97-67
· Spindle diameter (nitralloy)
6"
· No. 50 taper power draw bar
· Spindle Z axis travel
48"
· Headstock vertical travel Y-axis
120"
· Column cross travel X-axis
240"
· Spindle speeds (36) 8.3 to 500 RPM (main)
·
(36) 33 to 2000 (aux) needs retro-fit spindle
· Spindle feeds: .005 - .250 IPR
· Milling feeds: (18) .5 - 25 IPM
· Rapid traverse: 120 IPM
· Standard thread leads: 4, 5, 8, 10, 13, 16, 20
· 25 HP main drive 3/60/220-440V
· Power draw bar
· Hardened and ground bedways
· Jorgenson chip conveyor
· 3 axis Fagor digital readouts
· Right angle head
· Motorized tail stock with bedways
· Brand new way covers
· Pendant controls
· Coolant pump (air)
· Operators platform
· Miscellaneous tooling
· All associated electrical
· All manuals and drawings
· Oil lube pump for power draw bar and ways
· 8' X 20' T-slotted cast floor plate 12" thick
Within the last five years the following has been done: Replaced spindle
bearings and some head stock gears, reground spindle and spindle taper,
replaced pinion on rack in X-axis, added a new 3 axis Fagor digital
readout.
Machine was relocated and the following was just completed (no hours
since):
· Complete new paint job including operators platform, carriage,
ways,
column, ladder, chip conveyor, and all associated equipment on machine
· Complete new bearings and seals in carriage
· Fresh oil
· New way covers on bed (still in box)
· Updated electrical in MCC
· Complete power wash and inspect all components
· Open and inspected head stock
